Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 69)

show inlinepower
D-Series CLI Reference 2-31
Commands
The commands used to review and set system power parameters are listed below.
show inlinepower
Use this command to display system power properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display system power properties:
D2(su)->show inlinepower
Detection Mode : auto
Unit Status Power(W) Consumption(W) Usage(%) Threshold(%) Trap
---- ------ -------- -------------- -------- ------------ ----
1
auto 480 0.00 0.00 80 enable
set inlinepower threshold
Use this command to set the power usage threshold.
Syntax
set inlinepower threshold usage-threshold
Parameters
For information about... Refer to page...
show inlinepower 2-31
set inlinepower threshold 2-31
set inlinepower trap 2-32
show port inlinepower 2-32
set port inlinepower 2-33
threshold value Specifies a power threshold as a percentage of total system power usage.
Valid values are 11 to 100.