Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 433)

clear radius accounting
D-Series CLI Reference 15-9
clear radius accounting
Use this command to clear RADIUS accounting configuration settings.
Syntax
clear radius accounting {server ip-address | retries | timeout | counter}
Parameters
Mode
Switch command, read‐write.
Defaults
None.
Example
This example shows how to reset the RADIUS accounting timeout to 5 seconds.
D2(su)->clear radius accounting timeout
Configuring 802.1X Authentication
Purpose
To review and configure 802.1X authentication for one or more ports using EAPOL (Extensible
Authentication Protocol). 802.1X controls network access by enforcing user authorization on
selected ports, which results in allowing or denying network access according to RADIUS server
configuration.
Commands
server ip‐address Clears the configuration on one or more accounting servers.
retries Resets the retries to the default value of 3.
timeout Resets the timeout to 5 seconds.
counter Clears counters.
Note: To configure EAP pass-through, which allows client authentication packets to be forwarded
through the switch to an upstream device, 802.1X authentication must be globally disabled with the
set dot1x command (“
set dot1x ” on page 15-13).
For information about... Refer to page...
show dot1x 15-10
show dot1x auth-config 15-11
set dot1x 15-13
set dot1x auth-config 15-14
clear dot1x auth-config 15-15