Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 109)

show port counters
D-Series CLI Reference 4-5
Example
This example shows how to display status information for ge .3.14:
D2(su)->show port status ge.3.14
Port Alias Oper Admin Speed Duplex Type
(truncated) Status Status
------------ -------------- ------- ------- -------- ------- -------------
ge.3.14
up up N/A N/A BaseT RJ45
Table 4‐11 provides an explanation of the command output.
show port counters
Use this command to display port counter statistics detailing traffic through the device and
through all MIB2 network devices.
Syntax
show port counters [port-string] [switch | mib2]
Parameters
Defaults
If port‐string is not specified, counter statistics will be displayed for all ports.
If mib2 or switch are not specified, all counter statistics will be displayed for the specified port(s).
Table 4-11 show port status Output Details
Output Field What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“
Port String Syntax Used in the CLI ” on page 4-1.
Alias (truncated) Alias configured for the port. For details on using the set port alias command, refer
to “
set port alias ” on page 4-9.
Oper Status Operating status (up or down).
Admin Status Whether the specified port is enabled (up) or disabled (down). For details on using
the set port disable command to change the default port status of enabled, refer to
“
set port disable ” on page 4-7. For details on using the set port enable command to
re-enable ports, refer to “ set port enable ” on page 4-8.
Speed Operational speed in Mbps or Kbps of the specified port. For details on using the set
port speed command to change defaults, refer to “
set port speed ” on page 4-10.
Duplex Duplex mode (half or full) of the specified port. For details on using the set port
duplex command to change defaults, refer to “
Setting Auto-Negotiation and
Advertised Ability ” on page 4-14.
Type Physical port and interface type.
port‐string (Optional) Displays counter statistics for specific port(s). For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 4‐1.
switch | mib2 (Optional) Displays switch or MIB2 statistics. Switch statistics detail
performance of the D‐Series device. MIB2 interface statistics detail
performance of all network devices.