Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 50)

show system
2-12 Basic Configuration
show system
Use this command to display system information, including contact information, power and fan
tray status and uptime.
Syntax
show system
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display system information:
D2(su)->show system
System contact:
System location:
System name:
PWR1-A Status PWR1-B Status
---------- ----------
Ok Not Installed and/or Not Operating
PWR2-A Status PWR2-B Status
---------- ----------
Not Installed and/or Not Operating Not Installed and/or Not Operating
Fan1-Status Fan2-Status
----------- -----------
Not Installed and/or Not Operating Not Installed and/or Not Operating
Uptime d,h:m:s Logout
-------------- -------
2,20:23:11 30 min
Table 2‐6 provides an explanation of the command output.
Table 2-6 show system Output Details
Output What It Displays...
System contact Contact person for the system. Default of a blank string can be changed with the
set system contact command (“
set system contact ” on page 2-24).
System location Where the system is located. Default of a blank string can be changed with the
set system location command (“
set system location ” on page 2-23).
System name Name identifying the system. Default of a blank string can be changed with the
set system name command (“
set system name ” on page 2-23).
PWR1-A Status Operational status for the power supply connected to PWR1-A on the switch.
PWR1-B Status Operational status for the power supply connected to PWR1-B on the switch.
PWR2-A Status Operational status for the power supply connected to PWR2-A on the switch.