Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 474)

set maclock disable
15-50 Security Configuration
Usage
When enabled and configured, MAC locking defines which MAC addresses, as well as how many
MAC addresses are permitted to use specific port(s).
MAC locking is disabled by default at device startup. Configuring one or more ports for MAC
locking requires globally enabling it on the device and then enabling it on the desired ports.
Example
This example shows how to enable MAC locking on ge .2.3:
D2(su)->set maclock enable ge.2.3
set maclock disable
Use this command to disable MAC locking globally or on one or more ports.
Syntax
set maclock disable [port-string]
Parameters
Defaults
If port‐string is not specified, MAC locking will be disabled globally on the stack or standalone
device.
Mode
Switch command, read‐write.
Example
This example shows how to disable MAC locking on ge .2.3:
D2(su)->set maclock disable ge.2.3
set maclock
Use this command to create a static MAC address‐to‐port locking, and to enable or disable MAC
locking for the specified MAC address and port.
Syntax
set maclock mac-address port-string {create | enable | disable}
Parameters
port‐string (Optional) Disables MAC locking on specific port(s). For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 4‐1.
mac‐address Specifies the MAC address for which MAC locking will be created,
enabled or disabled.