Show cdp output details -2, Parameters defaults, Mode – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 94: Example
show cdp
3-2 Discovery Protocol Configuration
Parameters
Defaults
If port‐string is not specified, all CDP information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display CDP information for ports
ge
.1.1 through
ge
.1.9:
D2(su)->show cdp ge.1.1-9
CDP Global Status :auto-enable
CDP Version Supported :30 hex
CDP Hold Time :180
CDP Authentication Code :00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 hex
CDP Transmit Frequency :60
Port Status
-----------------
ge.1.1 auto-enable
ge.1.2 auto-enable
ge.1.3 auto-enable
ge.1.4 auto-enable
ge.1.5 auto-enable
ge.1.6 auto-enable
ge.1.7 auto-enable
ge.1.8 auto-enable
ge.1.9 auto-enable
provides an explanation of the command output.
port‐string
(Optional) Displays CDP status for a specific port. For a detailed description
of possible port‐string values, refer to
Port String Syntax Used in the CLI
Table 3-8 show cdp Output Details
Output Field
What It Displays...
CDP Global Status
Whether CDP is globally auto-enabled, enabled or disabled. The default state of
auto-enabled can be reset with the set cdp state command. For details, refer to “
CDP Versions
Supported
CDP version number(s) supported by the switch.
CDP Hold Time
Minimum time interval (in seconds) at which CDP configuration messages can be
set. The default of 180 seconds can be reset with the set cdp hold-time command.
For details, refer to “
CDP Authentication
Code
Authentication code for CDP discovery protocol. The default of 00-00-00-00-00-00-
00-00 can be reset using the set cdp auth command. For details, refer to “
CDP Transmit
Frequency
Frequency (in seconds) at which CDP messages can be transmitted. The default of
60 seconds can be reset with the set cdp interval command. For details, refer to “
Port
Port designation. For a detailed description of possible port-string values, refer to