Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 102)

set ciscodp holdtime
3-10 Discovery Protocol Configuration
Mode
Switch command, read‐write.
Example
This example shows how to set the Cisco DP timer to 120 seconds.
D2(su)->set ciscodp timer 120
set ciscodp holdtime
Use this command to set the time to live (TTL) for Cisco discovery protocol PDUs. This is the
amount of time, in seconds, neighboring devices will hold PDU transmissions from the sending
device.
Syntax
set ciscodp holdtime hold-time
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set Cisco DP hold time to 180 seconds:
D2(su)->set ciscodp hold-time 180
set ciscodp port
Use this command to set the status, voice VLAN, extended trust mode, and CoS priority for
untrusted traffic for the Cisco Discovery Protocol on one or more ports.
Syntax
set ciscodp port {[status {disable | enable}] [vvid {vlan-id | none | dot1p |
untagged}] [trusted {yes | no}] [cos value]} port-string
Parameters
hold‐time Specifies the time to live for Cisco DP PDUs. Valid values are from 10 to 255
seconds.
status Sets the CiscoDP port operational status.
disable Does not transmit or process CiscoDP PDUs.
enable Transmits and processes CiscoDP PDUs.
vvid Sets the port voice VLAN for CiscoDP PDU transmission.
vlan‐id Specifies the VLAN ID, range 1‐4094.