Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 271)

Creating Diffserv Classes and Matching Conditions
D-Series CLI Reference 8-3
Creating Diffserv Classes and Matching Conditions
Purpose
To review, create, and configure Diffserv classes and matching conditions.
Commands
The commands used to review, create, and configure Diffserv classes and matching conditions are
listed below and described in the associated section as shown.
show diffserv info
Use this command to display general Diffserv status information.
Syntax
show diffserv info
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display general Diffserv status information:
D2(rw)->show diffserv info
DiffServ Admin Mode............................ Enable
Class Table Size Current/Max................... 0 / 25
Class Rule Table Size Current/Max.............. 0 / 150
Policy Table Size Current/Max.................. 0 / 12
Policy Instance Table Size Current/Max......... 0 / 120
Policy Attribute Table Size Current/Max........ 0 / 120
Service Table Size Current/Max................. 0 / 48
For information about... Refer to page...
show diffserv info 8-3
show diffserv class 8-4
set diffserv class create 8-4
set diffserv class delete 8-5
set diffserv class match 8-5
set diffserv class rename 8-8