Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 230)

clear spantree adminedge
6-38 Spanning Tree Configuration
Defaults
None.
Mode
Switch command, read‐write.
Usage
The default behavior of the edge port administrative status begins with the value set to false
initially after the device is powered up. If a Spanning Tree BDPU is not received on the port within
a few seconds, the status setting changes to true.
Example
This example shows how to set ge .1.11 as an edge port:
D2(su)->set spantree adminedge ge.1.11 true
clear spantree adminedge
Use this command to reset a Spanning Tree port to non‐edge status.
Syntax
clear spantree adminedge port-string
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset ge .1.11 as a non‐edge port:
D2(su)->clear spantree adminedge ge.1.11
Configuring Spanning Tree Loop Protect Parameters
Purpose
To display and set Spanning Tree Loop Protect parameters, including the global parameters of
Loop Protect threshold, window, enabling traps, and disputed BPDU threshold, as well as per port
and port/SID parameters. See “
Loop Protect ” on page 6‐2 for more information about the Loop
Protect feature.
port‐string Specifies port(s) on which to reset edge port status. For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 4‐1.