Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 224)

set spantree portadmin
6-32 Spanning Tree Configuration
set spantree portadmin
Use this command to disable or enable the Spanning Tree algorithm on one or more ports.
Syntax
set spantree portadmin port-string {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable Spanning Tree on ge .1.5:
D2(rw)->set spantree portadmin ge.1.5 disable
clear spantree portadmin
Use this command to reset the default Spanning Tree admin status to enable on one or more ports.
Syntax
clear spantree portadmin port-string
show spantree portpri 6-33
set spantree portpri 6-34
clear spantree portpri 6-35
show spantree adminpathcost 6-35
set spantree adminpathcost 6-36
clear spantree adminpathcost 6-36
show spantree adminedge 6-37
set spantree adminedge 6-37
clear spantree adminedge 6-38
For information about... Refer to page...
port‐string Specifies the port(s) for which to enable or disable Spanning Tree. For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 4‐1.
disable | enable Disables or enables Spanning Tree.