Set sntp server, Clear sntp server, Set sntp server -28 clear sntp server -28 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 366: Command, Sntp server
set sntp server
12-28 Logging and Network Management
set sntp server
Use this command to add a server from which the SNTP client will retrieve the current time when
operating in unicast mode. Up to 10 servers can be set as SNTP servers.
Syntax
set sntp server ip-address [precedence]
Parameters
Defaults
If precedence is not specified, 1 will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to set the server at IP address 10.21.1.100
as an
SNTP server:
D2(su)->set sntp server 10.21.1.100
clear sntp server
Use this command to remove one or all servers from the SNTP server list.
Syntax
clear sntp server {ip-address | all}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to remove the server at IP address 10.21.1.100
from the SNTP server list:
D2(su)->clear sntp server 10.21.1.100
ip‐address
Specifies the SNTP server’s IP address.
precedence
(Optional) Specifies this SNTP server’s precedence in relation to its peers.
Valid values are 1 (highest) to 10 (lowest).
ip‐address
Specifies the IP address of a server to remove from the SNTP server list.
all
Removes all servers from the SNTP server list.