Clear policy rule, Clear policy rule -12 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 298
clear policy rule
9-12 Policy Classification Configuration
Examples
to assign a rule to policy profile 3 that will filter
Ethernet II Type 1526 frames to VLAN 7:
D2(su)->set policy rule 3 ether 1526 vlan 7
to assign a rule to policy profile 5 that will forward
UDP frames from source port 45:
D2(su)->set policy rule 5 udpportsource 45 forward
to assign a rule to policy profile 1 that will drop IP
source traffic from IP address 1.2.3.4. If mask 32 is not specified as shown, a default mask of 48 bits
(IP address + port) would be applied:
D2(su)->set policy rule 1 ipsourcesocket 1.2.3.4 mask 32 drop
clear policy rule
Use this command to delete policy classification rule entries.
Syntax
This command has two forms of syntax—one to clear an admin rule (for policy ID 0), and the
other to clear a classification rule.
clear policy rule admin-profile {vlantag data [mask mask]
clear policy rule profile-index {all-pid-entries | {ether | ipproto|
ipdestsocket| ipsourcesocket | iptos | macdest | macsource | tcpdestport |
tcpsourceport | udpdestport | udpsourceport}}
Parameters
The following parameters apply to deleting an admin rule.
The following parameters apply to deleting a classification rule.
Destination or Source UDP port:
udpsourceport
udpdestport
UDP Port Number:
0 - 65535 or 0 - 0xFFFF
1 - 16
vlantag
VLAN tag: 1- 4094
1 -12
Table 9-35 Valid Values for Policy Classification Rules (Continued)
Classification Rule Parameter
data value
mask bits
admin‐profile
Specifies that the rule to be deleted is an admin rule for policy ID 0.
vlantag data
Deletes the rule based on VLAN tag specified by data. Value of data can
range from 1 to 4094 or 0xFFF.
mask mask
(Optional) Specifies the number of significant bits to match, dependent
on the data value entered. Value of mask can range from 1 to 12.
Refer to
for valid values for each classification type and data
value.