Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 172)

clear snmp access
5-18 SNMP Configuration
If read view is not specified none will be applied.
If write view is not specified, none will be applied.
If notify view is not specified, none will be applied.
If storage type is not specified, entries will be stored as permanent and will be held through device
reboot.
Mode
Switch command, read‐write.
Example
This example permits the “powergroup” to manage all MIBs via SNMPv3:
D2(su)->set snmp access powergroup security-model usm
clear snmp access
Use this command to clear the SNMP access entry of a specific group, including its set SNMP
security‐model, and level of security.
Syntax
clear snmp access groupname security-model {v1 | v2c | usm} [noauthentication |
authentication | privacy] [context context]
Parameters
Defaults
If security level is not specified, all levels will be cleared.
If context is not specified, none will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to clear SNMP version 3 access for the “mis‐group” via the
authentication protocol:
D2(su)->clear snmp access mis-group security-model usm authentication
groupname Specifies the name of the SNMP group for which to clear access.
security‐model v1 |
v2c | usm Specifies the security model to be cleared for the SNMP access group.
noauthentication |
authentication |
privacy (Optional) Clears a specific security level for the SNMP access group.
context context (Optional) Clears a specific context for the SNMP access group. Enter / ‐ /
to clear the default context.