Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 185)

set snmp notify
D-Series CLI Reference 5-31
Defaults
If a notify name is not specified, all entries will be displayed.
If volatile, nonvolatile, or read‐only are not specified, all storage type entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display the SNMP notify information:
D2(su)->show snmp notify
--- SNMP notifyTable information ---
Notify name = 1
Notify Tag = Console
Notify Type = trap
Storage type = nonVolatile
Row status = active
Notify name = 2
Notify Tag = TrapSink
Notify Type = trap
Storage type = nonVolatile
Row status = active
Table 5‐26 provides an explanation of the command output.
set snmp notify
Use this command to set the SNMP notify configuration. This creates an entry in the SNMP notify
table, which is used to select management targets who should receive notification messages. This
command’s tag parameter can be used to bind each entry to a target address using the set snmp
targetaddr command (“
set snmp targetaddr ” on page 5‐26).
Syntax
set snmp notify notify tag tag [trap | inform] [volatile | nonvolatile]
Parameters
Table 5-26 show snmp notify Output Details
Output Field What It Displays...
Notify name A unique identifier used to index the SNMP notify table.
Notify Tag Name of the entry in the SNMP notify table.
Notify Type Type of notification: SNMPv1 or v2 trap or SNMPv3 InformRequest
message.
Storage type Whether access entry is stored in volatile, nonvolatile, or read-only
memory.
Row status Status of this entry: active, notInService, or notReady.
notify Specifies an SNMP notify name.