Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 442)

clear eapol
15-18 Security Configuration
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example shows how to enable EAPOL:
D2(su)->set eapol enable
This example shows how to enable EAPOL with forced authorized mode on port ge .1.1:
D2(su)->set eapol auth-mode forced-auth ge.1.1
clear eapol
Use this command to globally clear the EAPOL authentication mode, or to clear settings for one or
more ports.
Syntax
clear eapol [auth-mode] [port-string]
Parameters
Defaults
If auth‐mode is not specified, all EAPOL settings will be cleared.
If port‐string is not specified, settings will be cleared for all ports.
enable | disable Enables or disables EAPOL.
auth‐mode
auto |
forced‐auth |
forced‐unauth
Specifies the authentication mode as:
• auto ‐ Auto authorization mode. This is the default mode and will
forward frames according to the authentication state of the port. For
details on this mode, refer to
Table 15‐47 .
• forced‐auth ‐ Forced authorized mode, which disables authentication
on the port.
• forced‐unauth ‐ Forced unauthorized mode, which filters and discards
all frames received on the port.
port‐string Specifies the port(s) on which to set EAPOL parameters. For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 4‐1.
auth‐mode (Optional) Globally clears the EAPOL authentication mode.
port‐string Specifies the port(s) on which to clear EAPOL parameters. For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 4‐1.