Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 466)

show policy maptable response
15-42 Security Configuration
Commands
show policy maptable response
Displays the current policy maptable response setting. When VLAN authorization is enabled (as
described in this section) and the policy maptable response is tunnel, you can use the set
multiauth port command (page 15‐34) to set the number of RFC 3580 users (numusers) allowed
per Gigabit port.
Syntax
show policy maptable response
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the current policy maptable response setting:
D2(rw)->show policy maptable response
policy
set policy maptable response
Sets the maptable response from the default of policy to tunnel to allow up to VLAN authorized
users to be configured per Gigabit port.
Syntax
set policy maptable response {policy | tunnel}
For information about... Refer to page...
show policy maptable response 15-42
set policy maptable response 15-42
set vlanauthorization 15-43
set vlanauthorization egress 15-44
clear vlanauthorization 15-44
show vlanauthorization 15-45