Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 455)

show multiauth
D-Series CLI Reference 15-31
show multiauth
Use this command to display multiple authentication system configuration.
Syntax
show multiauth
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display multiple authentication system configuration:
D2(rw)->show multiauth
Multiple authentication system configuration
-------------------------------------------------
Supported types : dot1x, pwa mac
Maximum number of users : 768
Current number of users : 2
System mode : multi
Default precedence : dot1x, pwa, mac
Admin precedence
: dot1x, pwa, mac
Operational precedence : dot1x, pwa, mac
set multiauth mode
Use this command to set the system authentication mode to allow multiple authenticators
simultaneously (802.1xPWA, and MAC Authentication) on a single port, or to strictly adhere to
802.1x authentication.
Syntax
set multiauth mode {multi | strict}
set multiauth idle-timeout 15-38
clear multiauth idle-timeout 15-38
show multiauth session-timeout 15-39
set multiauth session-timeout 15-40
clear multiauth session-timeout 15-40
For information about... Refer to page...