Set port advertise, Set port advertise -16 – Enterasys Networks Enterasys D2 D2G124-12P User Manual

Page 120

set port advertise

4-16 Port Configuration

Parameters

Defaults

If port‐string is not specified, advertisement for all ports will be displayed.

Mode

Switch command, read‐only.

Example

This example shows how to display advertisement status for Gigabit ports 13 and 14:

D2(su)->show port advertise ge.1.13-14
ge.1.13 capability advertised remote
-------------------------------------------------
10BASE-T yes yes yes
10BASE-TFD yes yes yes
100BASE-TX yes yes yes
100BASE-TXFD yes yes yes
1000BASE-T no no no
1000BASE-TFD yes yes yes
pause yes yes no

ge.1.14 capability advertised remote
-------------------------------------------------
10BASE-T yes yes yes
10BASE-TFD yes yes yes
100BASE-TX yes yes yes
100BASE-TXFD yes yes yes
1000BASE-T no no no
1000BASE-TFD yes yes yes
pause yes yes no

set port advertise

Use this command to configure what a port will advertise for speed/duplex capabilities in auto‐
negotiation.

Syntax

set port advertise {port-string}{10t | 10tfd | 100tx | 100txfd | 1000t | 1000tfd
| pause}

Parameters

port‐string

(Optional) Displays advertised ability for specific port(s). For a
detailed description of possible port‐string values, refer to “

Port

String Syntax Used in the CLI

” on page 4‐1.

port‐string

Select the ports for which to configure advertisements. For a detailed
description of possible port‐string values, refer to “