Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 203)

clear spantree bridgeprioritymode
D-Series CLI Reference 6-11
Defaults
None
Mode
Switch command, read‐write.
Usage
The mode affects the range of priority values used to determine which device is selected as the
Spanning Tree root as described in set spantree priority (“
set spantree priority ” on page 6‐17). The
default for the switch is to use 802.1t bridge priority mode.
Example
This example shows how to set the bridge priority mode to 802.1D:
D2(rw)->set spantree bridgeprioritymode 8021d
clear spantree bridgeprioritymode
Use this command to reset the Spanning Tree bridge priority mode to the default setting of 802.1t.
Syntax
clear spantree bridgeprioritymode
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the bridge priority mode to 802.1t:
D2(rw)->clear spantree bridgeprioritymode
8021t Sets the bridge priority mode to use 802.1t values, which are 0 to 61440, in
increments of 4096. Values will automatically be rounded up or down,
depending on the 802.1t value to which the entered value is closest.
This is the default bridge priority mode.