Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 101)

set ciscodp status
D-Series CLI Reference 3-9
set ciscodp status
Use this command to enable or disable the Cisco discovery protocol globally on the switch.
Syntax
set ciscodp state {auto | disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to globally enable CiscoDP:
D2(su)->set ciscodp state enable
set ciscodp timer
Use this command to set the number of seconds between Cisco discovery protocol PDU
transmissions.
Syntax
set ciscodp timer seconds
Parameters
Defaults
None.
trusted The trust mode of the port. Default of trusted can be changed using the set ciscodp
port command.
cos The Class of Service priority value for untrusted traffic. The default of 0 can be
changed using the set ciscodp port command.
Table 3-10 show ciscodp port info Output Details (Continued)
Output Field What It Displays...
auto Globally enable only if Cisco DP PDUs are received.
disable Globally disable Cisco discovery protocol.
enable Globally enable Cisco discovery protocol.
seconds Specifies the number of seconds between Cisco DP PDU transmissions.
Valid values are from 5 to 254 seconds.