Set spantree hello, Clear spantree hello, Set spantree hello -18 clear spantree hello -18 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 210: Refer to
set spantree hello
6-18 Spanning Tree Configuration
Example
This example shows how to reset the bridge priority on SID 1:
D2(su)->clear spantree priority 1
set spantree hello
Use this command to set the device’s Spanning Tree hello time, This is the time interval (in
seconds) the device will transmit BPDUs indicating it is active.
Syntax
set spantree hello interval
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to globally set the Spanning Tree hello time to 10 seconds:
D2(su)->set spantree hello 10
clear spantree hello
Use this command to reset the Spanning Tree hello time to the default value of 2 seconds.
Syntax
clear spantree hello
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to globally reset the Spanning Tree hello time:
D2(su)->clear spantree hello
interval
Specifies the number of seconds the system waits before broadcasting a
bridge hello message (a multicast message indicating that the system is
active). Valid values are 1 ‐ 10.