Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 183)

show newaddrtrap
D-Series CLI Reference 5-29
show newaddrtrap
Use this command to display the global and port‐specific status of the SNMP new MAC addresses
trap function.
Syntax
show newaddrtrap [port-string]
Parameters
Defaults
If port‐string is not specified, the status of the new MAC addresses trap function will be displayed
for all ports.
Mode
Switch command, read‐only.
Usage
By default, this function is disabled globally and per port.
Example
This example displays the status for Gigabit Ethernet ports 1 through 5 in slot 1.
D2(ro)->show newaddrtrap ge.1.1-5
New Address Traps Globally disabled
Port Enable State
--------- ------------
ge.1.1 disabled
ge.1.2 disabled
ge.1.3 disabled
ge.1.4 disabled
ge.1.5 disabled
show snmp notifyfilter 5-33
set snmp notifyfilter 5-33
clear snmp notifyfilter 5-34
show snmp notifyprofile 5-35
set snmp notifyprofile 5-35
clear snmp notifyprofile 5-36
For information about... Refer to page...
port‐string (Optional) Displays the status of the new MAC addresses trap function
on specific ports.