Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 99)

show ciscodp
D-Series CLI Reference 3-7
Commands
The commands used to review and configure the Cisco discovery protocol are listed below. Refer
also to “
show neighbors ” on page 3‐6.
show ciscodp
Use this command to display global Cisco discovery protocol information.
Syntax
show ciscodp
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display global Cisco DP information.
D2(su)->show ciscodp
CiscoDP :Enabled
Timer :5
Holdtime (TTl): 180
Device ID : 001188554A60
Last Change : WED NOV 08 13:19:56 2006
Table 3‐9 provides an explanation of the command output.
For information about... Refer to page...
show ciscodp 3-7
show ciscodp port info 3-8
set ciscodp status 3-9
set ciscodp timer 3-9
set ciscodp holdtime 3-10
set ciscodp port 3-10
clear ciscodp 3-12
Table 3-9 show ciscodp Output Details
Output Field What It Displays...
CiscoDP Whether Cisco DP is globally enabled or disabled. Auto indicates that Cisco DP will
be globally enabled only if Cisco DP PDUs are received.
Default setting of auto-enabled can be reset with the set ciscodp status command.