Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 116)

Enabling / Disabling Jumbo Frame Support
4-12 Port Configuration
Mode
Switch command, read‐write.
Example
This example shows how to set ge.1.17 to full duplex:
D2(su)->set port duplex ge.1.17 full
Enabling / Disabling Jumbo Frame Support
Purpose
To review, enable, and disable jumbo frame support on one or more ports. This allows Gigabit
Ethernet ports to transmit frames up to 10 KB in size.
Commands
show port jumbo
Use this command to display the status of jumbo frame support and maximum transmission units
(MTU) on one or more ports.
Syntax
show port jumbo [port-string]
Parameters
Defaults
If port‐string is not specified, jumbo frame support status for all ports will display.
Mode
Switch command, read‐only.
For information about... Refer to page...
show port jumbo 4-12
set port jumbo 4-13
clear port jumbo 4-13
port‐string (Optional) Displays the status of jumbo frame support for specific
port(s). For a detailed description of possible port‐string values, refer to
“
Port String Syntax Used in the CLI ” on page 4‐1.