Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 382)

set rmon alarm status
13-10 RMON Configuration
Defaults
interval ‐ 3600 seconds
type ‐ absolute
startup ‐ rising
rthresh ‐ 0
fthresh ‐ 0
revent ‐ 0
fevent ‐ 0
owner ‐ monitor
Mode
Switch command, read‐write.
Example
This example shows how to configure a rising RMON alarm. This entry will conduct monitoring
of the delta between samples every 30 seconds:
D2(rw)->set rmon alarm properties 3 interval 30 object
1.3.6.1.4.1.5624.1.2.29.1.2.1.0 type delta rthresh 1 revent 2 owner Manager
set rmon alarm status
Use this command to enable an RMON alarm entry. An alarm is a notification that a statistical
sample of a monitored variable has crossed a configured threshold.
Syntax
set rmon alarm status index enable
startup rising |
falling | either (Optional) Specifies the type of alarm generated when this event is first
enabled as:
• Rising ‐ Sends alarm when an RMON event reaches a maximum
threshold condition is reached, for example, more than 30 collisions
per second.
• Falling ‐ Sends alarm when RMON event falls below a minimum
threshold condition, for example when the network is behaving
normally again.
• Either ‐ Sends alarm when either a rising or falling threshold is
reached.
rthresh rthresh (Optional) Specifies a minimum threshold for causing a rising alarm.
fthresh fthresh Specifies a maximum threshold for causing a falling alarm.
revent revent Specifies the index number of the RMON event to be triggered when the
rising threshold is crossed.
fevent fevent Specifies the index number of the RMON event to be triggered when the
falling threshold is crossed.
owner owner (Optional) Specifies the name of the entity that configured this alarm
entry.