Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 239)

clear spantree lpwindow
D-Series CLI Reference 6-47
clear spantree lpwindow
Use this command to reset the Loop Protect event window to the default value of 180 seconds.
Syntax
clear spantree lpwindow
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the Loop Protect event window to the default of 180 seconds:
D2(rw)->clear spantree lpwindow
set spantree lptrapenable
Use this command to enable or disable Loop Protect event notification.
Syntax
set spantree lptrapenable {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Usage
Loop Protect traps are sent when a Loop Protect event occurs, that is, when a port goes to listening
due to not receiving BPDUs. The trap indicates port, SID and loop protection status.
Example
This example shows how to enable sending of Loop Protect traps:
D2(rw)->set spantree lptrapenable enable
enable | disable Enables or disables the sending of Loop Protect traps. Default is
disabled.