Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 365)

set sntp client
D-Series CLI Reference 12-27
set sntp client
Use this command to set the SNTP operation mode.
Syntax
set sntp client {broadcast | unicast | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable SNTP in broadcast mode:
D2(su)->set sntp client broadcast
clear sntp client
Use this command to clear the SNTP client’s operational mode.
Syntax
clear sntp client
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the SNTP client’s operational mode:
D2(su)->clear sntp client
broadcast Enables SNTP in broadcast client mode.
unicast Enables SNTP in unicast (point‐to‐point) client mode. In this mode, the
client must supply the IP address from which to retrieve the current time.
disable Disables SNTP.