Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 40)

Setting User Accounts and Passwords
2-2 Basic Configuration
Setting User Accounts and Passwords
Purpose
To change the switch’s default user login and password settings, and to add new user accounts
and passwords.
Commands
The commands used to configure user accounts and passwords are listed below.
Table 2-4 Optional CLI Setup Commands
Task CLI commands
Refer to
page...
Save the active configuration. save config 2-41
Enable or disable SSH. set ssh enable | disable 15-69
Enable or disable Telnet. set telnet {enable | disable} [inbound |
outbound | all] 2-38
Enable or disable HTTP
management (WebView). set webview {enable | disable} 2-52
Enable or disable SNMP port link
traps. set port trap port-string {enable | disable} 4-20
Set the per port broadcast limit set port broadcast port-string threshold-value 4-29
Configure a VLAN. set vlan create vlan-id 7-4
set port vlan port-string vlan-id modify-egress 7-8
Set a Syslog server IP and
severity set logging server index ip-addr ip-addr
severity severity state enable 7-8
Configure and enable a RADIUS
server. set radius server index ip-addr
port [secret-value]{realm {management-access |
any | network-access} 15-5
set radius enable 15-5
Configure and enable first arrival
MAC locking on user ports. set maclock firstarrival port-string value 15-54
set maclock enable port-string 15-49
For information about... Refer to page...
show system login 2-3
set system login 2-4
clear system login 2-4
set password 2-5
set system password length 2-6
set system password aging 2-6
set system password history 2-7
show system lockout 2-7