Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 440)

show eapol
15-16 Security Configuration
This example shows how to reset the 802.1X quiet period to 60 seconds on ports ge .1.1‐3:
D2(su)->clear dot1x auth-config quietperiod ge.1.1-3
show eapol
Use this command to display EAPOL status or settings for one or more ports.
Syntax
show eapol [port-string]
Parameters
Defaults
If port‐string is not specified, only EAPOL enable status will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display EAPOL status for ports ge .1.1‐3:
D2(su)->show eapol ge.1.1-3
EAPOL is disabled.
Port Authentication State Authentication Mode
-------- -------------------- --------------------
ge.1.1 Initialize Auto
ge.1.2 Initialize Auto
ge.1.3 Initialize Auto
Table 15‐47 provides an explanation of the command output. For details on using the set eapol
command to enable the protocol and assign an authentication mode, refer to “ set eapol ” on
page 15‐17.
port‐string (Optional) Displays EAPOL status for specific port(s). For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 4‐1.
Table 15-47 show eapol Output Details
Output Field What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“
Port String Syntax Used in the CLI ” on page 4-1.