Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 347)

show logging local
D-Series CLI Reference 12-9
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the logging severity level to 6 for SNMP.
D2(rw)->clear logging application SNMP
show logging local
Use this command to display the state of message logging to the console and a persistent file.
Syntax
show logging local
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the state of message logging. In this case, logging to the
console is enabled and logging to a persistent file is disabled.
D2(su)->show logging local
Syslog Console Logging enabled
Syslog File Logging disabled
set logging local
Use this command to configure log messages to the console and a persistent file.
Syntax
set logging local console {enable | disable} file {enable | disable}
mnemonic Resets the severity level for a specific application to 6. Valid mnemonic
values and their corresponding applications are listed in
Table 12‐38 on
page 12‐8.
all Resets the severity level for all applications to 6.