Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 74)

Reviewing and Selecting a Boot Firmware Image
2-36 Basic Configuration
Reverting to a Previous Image
In the event that you need to downgrade to a previous version of code, you can do so by
completing the following steps described in this chapter.
1. Save your configuration, as described in“ save config ” (page 2‐41).
2. Load your previous version of code on the device, as described in “ Downloading a Firmware
Image ” (page 2‐33).
3. Set this older version of code to be the boot code, as described in “ Reviewing and Selecting a
Boot Firmware Image ” (page 2‐36).
4. Reload the saved configuration onto the device as described in“ configure ” (page 2‐45).
Reviewing and Selecting a Boot Firmware Image
Purpose
To display and set the image file the switch loads at startup. The D2 switch allows you to
download and store a backup image, which can be selected as the startup image by using the
commands described in this section.
Commands
The commands used to review and select the switch’s boot image file are listed below.
show boot system
Use this command to display the firmware image the switch loads at startup.
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Note: You will not be able to peform these steps remotely unless you have remote console support.
For information about... Refer to page...
show boot system 2-36
set boot system 2-37