H3C Technologies H3C S3100 Series Switches - Manual (Page 68)

Operation Manual – Login
H3C S3100-52P Ethernet Switch Chapter 3 Logging in through Telnet
3-17
Workstation
Workstation Server PC w ith T
running on i
(used to c
the switch
elnet
t
onfigure
)
Ethernet port
Ethernet
Workstation
Workstation Server PC w ith T
running on i
(used to c
the switch
elnet
t
onfigure
)
Ethernet port
Ethernet
Figure 3-6
Network diagram for Telnet connection establishment
4) Launch Telnet on your PC, with the IP address of the management VLAN interface
of the switch as the parameter, as shown in Figure 3-7.
Figure 3-7
Launch Telnet
5) Enter the password when the Telnet window displays “Login authentication” and
prompts for login password. The CLI prompt (such as ) appears if the
password is correct. If all VTY user interfaces of the switch are in use, you will fail
to establish the connection and receive the message that says “All user interfaces
are used, please try later!”. A H3C series Ethernet switch can accommodate up to
five Telnet connections at same time.
6) After successfully Telneting to a switch, you can configure the switch or display the
information about the switch by executing corresponding commands. You can
also type ? at any time for help. Refer to the following chapters for the information
about the commands.