H3C Technologies H3C S3100 Series Switches - Manual (Page 561)

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch Chapter 1 Information Center
1-10
Operation Command Description
Enable the
information center
info-center enable
Optional
By default, the information
center is enabled.
Enable information
output to Telnet
terminal or dumb
terminal
info-center monitor
channel
{ channel-number |
channel
-name }
Required
By default, a switch outputs
log/debugging/trap
information to user terminal
through information channel
1.
Define an
information source
info
-center source
{ modu-name | default }
channel
{ channel-number |
channel
-name } [ { log | trap
| debug } { level severity |
state
state } ]*
Required
Set the format of
time stamp
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Optional
This is to set the time stamp
format for log/debugging/trap
information output.
This determines how the time
stamp is presented to users.
Note:
z
When there are multiple Telnet users or dumb terminal users, they share some
configuration parameters including module filter, language and severity level
threshold. In this case, change to any such parameter made by one user will also be
reflected on all other user terminals.
z
To view debugging information of specific modules, you need to set the information
type as debug when defining the information source, and enable debugging for
corresponding modules through the debugging command.
To view the debugging/log/trap output information on the monitor terminal, you should
enable the corresponding debugging/log/trap display function on the switch.
For example, to view log information of the switch on a monitor terminal, you need to
not only enable log information output to the monitor terminal, but also enable log
information terminal display function with the terminal logging command.
Perform the following configuration in user view.