H3C Technologies H3C S3100 Series Switches - Manual (Page 40)

Operation Manual – Login
H3C S3100-52P Ethernet Switch Chapter 2 Logging in through the Console Port
2-6
2.4 Console Port Login Configuration with Authentication
Mode Being None
2.4.1 Configuration Procedure
Table 2-4
Console port login configuration with the authentication mode being none
Operation Command Description
Enter system view
system-view
—
Enter AUX user interface view
user-interface aux
0 —
Configure not to authenticate
users
authentication-mode
none
Required
By default, users
logging in through
the Console port are
not authenticated.
Set the baud
rate
speed
speed-value
Optional
The default baud
rate of an AUX port
(also the Console
port) is 9,600 bps.
Set the check
mode
parity
{ even | none |
odd
}
Optional
By default, the check
mode of a Console
port is set to none,
that is, no check bit.
Set the stop
bits
stopbits
{ 1 | 1.5 | 2 }
Optional
The stop bits of a
Console port is 1.
Configure the
Console port
Set the data
bits
databits
{ 7 | 8 }
Optional
The default data bits
of a Console port is
8.
Configure the command level
available to users logging into
the user interface
user privilege level
level
Optional
By default,
commands of level 3
are available to
users logging into
the AUX user
interface.
Make terminal services
available
shell
Optional
By default, terminal
services are
available in all user
interfaces.