H3C Technologies H3C S3100 Series Switches - Manual (Page 269)

Operation Manual – Routing Protocol
H3C S3100-52P Ethernet Switch Chapter 2 Static Route Configuration
2-2
(ICMP) packet will be returned to inform the source host that the destination host or
network is unreachable.
2.2 Static Route Configuration
2.2.1 Configuration Prerequisites
Before configuring a static route, perform the following tasks:
z
Configuring the physical parameters of the related interface
z
Configuring the link layer attributes of the related interface
z
Configuring an IP address for the related interface
2.2.2 Configuring a Static Route
Table 2-1
Configure a static route
Operation Command Description
Enter system view
system-view
—
Add a static route
ip route-static ip-address
{ mask |
mask-length
} { interface-type
interface-number
| next-hop }
[ preference value ] [ reject |
blackhole
] [ description text |
detect-group
group number ]*
Required
By default, the system
can obtain the route to
the subnet directly
connected to the
router.
Delete all static
routes
delete static-routes all
Optional
This command
deletes all static
routes, including the
default route.
Note:
z
If the destination IP address and the mask of a route are both 0.0.0.0, the route is
the default route. Any packet for which the router fails to find a matching entry in the
routing table will be forwarded through the default route.
z
Do not configure the next hop address of a static route to the address of an interface
on the local switch.
z
Different preferences can be configured to implement flexible route management
policy.