H3C Technologies H3C S3100 Series Switches - Manual (Page 453)

Operation Manual – SNMP and RMON
H3C S3100-52P Ethernet Switch Chapter 1 SNMP Configuration
1-8
1.4 Enabling Logging for Network Management
Table 1-5
Enable logging for network management
Operation Command Description
Enter system view
system-view
—
Enable logging for
network
management
snmp-agent log
{
set-operation
|
get-operation
| all }
Optional;
By default, SNMP logging is
disabled.
Note:
In the environment of a single device, use the display logbuffer command to view the
log of the get and set operations requested by the NMS.
1.5 Displaying SNMP
After the above configuration, you can execute the display command in any view to
view the running status of SNMP, and to verify the configuration.
Table 1-6
Display SNMP
Operation Command Description
Display the SNMP information
about the current device
display snmp-agent sys-info
[ contact | location | version ]*
Display SNMP packet statistics display snmp-agent statistics
Display the engine ID of the
current device
display snmp-agent
{ local-engineid |
remote-engineid
}
Display group information
about the device
display snmp-agent group
[ group-name ]
Display SNMP user
information
display snmp-agent usm-user
[ engineid engineid | username
user-name
| group group-name ]
Display Trap list information
display snmp-agent trap-list
Display the currently
configured community name
display snmp-agent community
[ read | write ]
Display the currently
configured MIB view
display snmp-agent mib-view
[ exclude | include | viewname
view-name
]
These
commands
can be
executed in
any view.