H3C Technologies H3C S3100 Series Switches - Manual (Page 419)

Operation Manual – Mirroring
H3C S3100-52P Ethernet Switch Chapter 1 Mirroring Configuration
1-10
Operation Command Description
Enter Ethernet port
view of the port
connecting to the
source switch or an
intermediate switch
interface interface-type
interface-number
—
Configure the current
port as Trunk port
port link-type trunk
Required
By default, the port
type is Access.
Configure Trunk port to
permit packets from
the remote-probe
VLAN
port trunk permit vlan
remote
-probe-vlan-id
Required
This configuration is
necessary for ports
through which the
destination switch is
connected to the
source switch or an
intermediate switch.
Exit the current view
quit
—
Configure a remote
destination mirroring
group
mirroring-group group-id
remote-destination
Required
Configure the
destination port for
remote mirroring
mirroring-group group-id
monitor-port monitor-port
Required
The destination port for
remote mirroring must
be of the Access type.
LACP and STP must
be disabled on this
port.
After you configure a
port as the destination
port for remote
mirroring, the switch
does not allow you to
change the port type or
its default VLAN ID.
Configure the
remote-probe VLAN
for the remote
destination mirroring
group
mirroring-group group-id
remote-probe vlan
remote
-probe-vlan-id
Required
Display the
configuration of the
remote destination
mirroring group
display mirroring-group
remote-destination
Optional
This command can be
executed in any view.