H3C Technologies H3C S3100 Series Switches - Manual (Page 129)

Operation Manual – Port Basic Configuration
H3C S3100-52P Ethernet Switch Chapter 1 Port Basic Configuration
1-7
1.2.7 Copying the Configuration of a Port to Other Ports
To make some other ports have the same configuration as that of a specific port, you
can copy the configuration of the specific port to the ports.
Specifically, the following types of port configuration can be copied from one port to
other ports: VLAN configuration, protocol-based VLAN configuration, LACP
configuration, QoS configuration, GARP configuration, STP configuration and initial
port configuration.
z
VALN configuration: includes IDs of the VLANs allowed on the port and the default
VLAN ID of the port;
z
Protocol-based VLAN configuration: includes IDs and indexes of the
protocol-based VLANs allowed on the port;
z
Link aggregation control protocol (LACP) configuration: includes LACP
enable/disable status;
Note:
The copy command can only be used to copy the configuration of LACP’s enable state,
but not to copy the configuration of aggregation group, i.e., you can not add a port to the
aggregation group bye the command.
z
QoS configuration: includes rate limit, port priority, and default 802.1p priority on
the port;
z
STP configuration: includes STP enable/disable status on the port, link attribute on
the port (point-to-point or non-point-to-point), STP priority, path cost, packet
transmission rate limit, whether loop protection is enabled, whether root protection
is enabled, and whether the port is an edge port;
z
Generic attribute registration protocol (GARP) configuration: includes GVRP
enable/disable status, timer settings, and registration mode;
z
Port configuration: includes link type of the port, port rate and duplex mode.
Table 1-9
Copy the configuration of a port to other ports
Operation Command Remarks
Enter system view system-view —
Copy the
configuration of a
port to other ports
copy configuration source
{ interface-type
interface-number
| aggregation-group
source-agg-id
} destination { interface-list
[ aggregation-group destination-agg-id ] |
aggregation-group
destination-agg-id }
Required