H3C Technologies H3C S3100 Series Switches - Manual (Page 586)

Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
Chapter 1 BootROM and Host Software
Loading
1-14
II. Loading Process Using FTP Server
As shown in Figure 1-9, the switch is used as the FTP server. You can telnet to the
switch, and then execute the FTP commands to download the BootROM program
S3100-52P.btm from the switch.
1) Loading
BootROM
Switch
PC
Ethernet port
10.1.1.1
Internet
FT
FTP Server
192.168.0.39
P Client
Switch
PC
Ethernet port
10.1.1.1
Internet
FT
FTP Server
192.168.0.39
P Client
r
Figure 1-9
Remote loading using FTP serve
Step 1: As shown in Figure 1-9, connect the switch through an Ethernet port to the PC
(with IP address 10.1.1.1)
Step 2: Configure the IP address of VLAN1 on the switch to 192.168.0.39, and subnet
mask to 255.255.255.0.
Note:
You can configure the IP address for any VLAN on the switch for FTP transmission.
However, before configuring the IP address for a VLAN interface, you have to make
sure whether the IP addresses of this VLAN and PC are routable.
system-view
System View: return to User View with Ctrl+Z.
[H3C] interface Vlan-interface 1
[H3C-Vlan-interface1] ip address 192.168.0.39 255.255.255.0
Step 3: Enable FTP service on the switch, configure the FTP user name to test and
password to pass.
[H3C-Vlan-interface1] quit
[H3C] ftp server enable
[H3C] local-user test
New local user added.
[H3C-luser-test] password simple pass