H3C Technologies H3C S3100 Series Switches - Manual (Page 565)

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch Chapter 1 Information Center
1-14
Note:
z
To view debug information of specific modules, you need to set the information type
as debug in the info-center source command, and enable debugging on
corresponding modules with the debugging command as well.
z
To send information to a remote SNMP workstation properly, related configurations
are required on both the switch and the SNMP workstation.
1.3 Displaying and Debugging Information Center
After the above configurations, you can execute the display command in any view to
display the running status of the information center, and thus validating your
configurations. You can also execute the reset command in user view to clear the
information in the log buffer and trap buffer.
Table 1-13
Display and debug information center
Operation Command Description
Display information on
an information channel
display channel
[ channel-number |
channel
-name ]
Display the operation
status of information
center, the
configuration of
information channels,
the format of time
stamp and the
information output in
case of fabric
display info-center
[ unit unit-id ]
Display the status of
log buffer and the
information recorded in
log buffer
display logbuffer
[ unit unit-id ]
[ level severity | size buffersize ]* [ |
{ begin | exclude | include }
regular-expression
]
Display the summary
information recorded in
log buffer
display logbuffer
summary [ level
severity
]
Display the status of
trap buffer and the
information recorded in
trap buffer
display trapbuffer
[ unit unit-id ]
[ size buffersize ]
The
display
command can be
executed in any
view
Clear information
recorded in log buffer
reset logbuffer
[ unit unit-id ]
Clear information
recorded in trap buffer
reset trapbuffer
[ unit unit-id ]
The
reset
command can be
executed in user
view