H3C Technologies H3C S3100 Series Switches - Manual (Page 211)

Operation Manual – MSTP
H3C S3100-52P Ethernet Switch
Chapter 1 MSTP Configuration
1-36
1.5.3 Configuring BPDU Protection
I. Configuration procedure
Table 1-30 Configure BPDU protection
Operation Command Description
Enter system view system-view —
Enable the BPDU
protection function stp
bpdu-protection
Required
The BPDU protection function
is disabled by default.
II. Configuration example
# Enable the BPDU protection function.
system-view
[H3C] stp bpdu-protection
Caution:
As Gigabit ports of an S3100-52P Ethernet switch cannot be shut down, the BPDU
protection function is not applicable to these ports even if you enable the BPDU
protection function and specify these ports to be MSTP edge ports.
1.5.4 Configuring Root Protection
I. Configuration procedure
Table 1-31 Configure the root protection function in system view
Operation Command Description
Enter system view system-view —
Enable the root protection
function on specified
ports stp interface
interface-list
root-protection
Required
The root protection function
is disabled by default.