H3C Technologies H3C S3100 Series Switches - Manual (Page 415)

Operation Manual – Mirroring
H3C S3100-52P Ethernet Switch Chapter 1 Mirroring Configuration
1-6
Operation Command Description
Display the mirroring
parameter settings
display mirroring-group
{ all |
local
}
Optional
This command can be
executed in any view.
Note:
z
Configurations listed in Table 1-2 do not involve specifying a mirroring group.
Therefore these mirroring settings made in Ethernet port view applies to mirroring
group 1 only.
z
Configurations listed in Table 1-3 can be used to add mirroring settings for any
defined mirroring group in Ethernet port view.
z
Configurations listed in Table 1-4 are performed in system view. Therefore the
mirroring group ID and port number must be specified.
IV. Configuration Example
Network requirements:
z
The source port is GigabitEthernet 1/1/1. All packets received and sent by this port
are to be mirrored.
z
The destination port is GigabitEthernet 1/1/4.
Configuration procedure 1:
system-view
[H3C] mirroring-group 1 local
[H3C] interface gigabitEthernet 1/1/4
[H3C-GigabitEthernet1/1/4] monitor-port
[H3C-GigabitEthernet1/1/4] quit
[H3C] interface gigabitEthernet 1/1/1
[H3C-GigabitEthernet1/1/1] mirroring-port both
Configuration procedure 2:
system-view
[H3C] mirroring-group 1 local
[H3C] interface GigabitEthernet 1/1/4
[H3C-GigabitEthernet1/1/4] mirroring-group 1 monitor-port
[H3C-GigabitEthernet1/1/4] quit
[H3C] interface GigabitEthernet 1/1/1
[H3C-GigabitEthernet1/1/1] mirroring-group 1 mirroring-port both
Configuration procedure 3:
system-view