H3C Technologies H3C S3100 Series Switches - Manual (Page 595)

Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
Chapter 2 Basic System Configuration
& Debugging
2-6
2.3.2 Displaying Debugging Status
Table 2-12
Display the current debugging status in the system
Operation Command Description
Display all enabled
debugging on the
specified device
display debugging
{ unit
unit-id
} [ interface
interface-type
interface-number
|
module-name
]
You can execute the display
command in any view.
2.3.3 Displaying Operating Information about Modules in System
When your Ethernet switch is in trouble, you may need to view a lot of operating
information to locate the problem. Each functional module has its own operating
information display command(s). You can use the command here to display the current
operating information about the modules (settled when this command is designed) in
the system for troubleshooting your system.
Perform the following operation in any view.
Table 2-13
Display the current operation information about the modules in the system.
Operation Command Description
Display the current
operation information
about the modules in the
system.
display
diagnostic-info
rmation
You can execute this command
twice and find the difference
between the two executing results
to locate the problem.