H3C Technologies H3C S3100 Series Switches - Manual (Page 107)

Operation Manual – IP Address and Performance Confiugration
H3C S3100-52P Ethernet Switch Chapter 1 IP Address Configuration
1-4
z
Manually configured by using the IP address configuration command
z
Allocated by the BOOTP server
z
Allocated by the DHCP server
The three methods are mutually exclusive and the use of a new method will result in the
IP address obtained by the old method being released. For example, if you obtain an IP
address by using the IP address configuration command, and then use the ip address
bootp-alloc
command to apply for an IP address, the originally configured IP address
is deleted and a new IP address will be allocated by BOOTP for the VLAN interface.
This chapter only introduces how to configure an IP address with the IP address
configuration command. For the other two methods, refer to the “Management VLAN
Configuration” module.
1.3 Configuring an IP Address for a VLAN Interface
Generally, it is enough to configure one IP address for a VLAN interface. However, you
can configure up to five IP addresses for a VLAN interface so that the interface can be
connected to several subnets. Among these IP addresses, one is the primary IP
address and the others are secondary ones.
Table 1-2
Configure an IP address for a VLAN interface
Operation Command Description
Enter system view
system-view
—
Enter VLAN interface
view
interface
Vlan-interface vlan-id
—
Configure an IP address
for a VLAN interface
ip
address ip-address
{ mask | mask-length }
[ sub ]
Required
By default, a VLAN interface
has no IP address.
After an IP address is
assigned to the VLAN
interface through BOOTP or
DHCP, you cannot configure a
secondary IP address for the
VLAN interface.
1.4 Displaying IP Address Configuration
After the above configuration, you can execute the display command in any view to
display the operating status and configuration on the interface to verify your
configuration.