H3C Technologies H3C S3100 Series Switches - Manual (Page 201)

Operation Manual – MSTP
H3C S3100-52P Ethernet Switch
Chapter 1 MSTP Configuration
1-26
II. Configuration example
# Enable MSTP on the switch and disable MSTP on Ethernet1/0/1.
1) Perform this configuration in system view.
system-view
[H3C] stp enable
[H3C] stp interface ethernet1/0/1 disable
2) Perform this configuration in Ethernet port view.
system-view
[H3C] stp enable
[H3C] interface ethernet1/0/1
[H3C-Ethernet1/0/1] stp disable
1.3 Configuring Leaf Nodes
Table 1-21 lists MSTP-related configurations about leaf nodes.
Table 1-21 Configure leaf nodes
Operation Description Related section
Enable the MSTP feature
Required
To prevent network
topology jitter caused by
other related
configurations, you are
recommended to enable
MSTP after performing
other configurations.
Section 1.2.14 “Enabling
the MSTP Feature”
Configure the MST region Required
Section 1.2.2
“Configuring the MST
region”
Configure the MSTP
operation mode
Optional
Section 1.2.5
“Configuring the MSTP
Packet Format”
Configure the timeout
time factor
Optional
Section 1.2.10
“Configuring the Timeout
Time Factor”
Configure the maximum
transmitting speed on the
current port
Optional
The default value is
recommended.
Section 1.2.11
“Configuring the
Maximum Transmitting
Speed on the Current
Port”
Configure the current port
as an edge port
Optional
Section 1.2.12
“Configuring the Current
Port as an Edge Port”