H3C Technologies H3C S3100 Series Switches - Manual (Page 418)

Operation Manual – Mirroring
H3C S3100-52P Ethernet Switch Chapter 1 Mirroring Configuration
1-9
III. Configuring RSPAN on the intermediate switch
Table 1-6
Configure RSPAN on the intermediate switch
Operation Command Description
Enter system view
system-view
—
Create a VLAN and enter
VLAN view
vlan
vlan-id
vlan-id is the ID of the
remote-probe VLAN to be
defined.
Define the current VLAN as
a remote-probe VLAN
remote-probe vlan
enable
Required
Exit the current view
quit
—
Enter Ethernet port view of
the port connecting to the
source switch, destination
switch or other intermediate
switch
interface interface-type
interface-number
—
Configure the current port
as Trunk port
port link-type trunk
Required
By default, the port type is
Access.
Configure Trunk port to
permit packets from the
remote-probe VLAN
port trunk permit vlan
remote
-probe-vlan-id
Required
This configuration is
necessary for ports on
the intermediate switch
that are connected to the
source switch, the
destination switch or
other intermediate switch.
IV. Configuring RSPAN on the destination switch
Table 1-7
Configure RSPAN on the destination switch
Operation Command Description
Enter system view
system-view
—
Create a VLAN and
enter VLAN view
vlan
vlan-id
vlan-id is the ID of the
remote-probe VLAN to
be defined.
Define the current
VLAN as a
remote-probe VLAN
remote-probe vlan enable
Required
Exit the current view
quit
—