H3C Technologies H3C S3100 Series Switches - Manual (Page 297)

Operation Manual – 802.1x
H3C S3100-52P Ethernet Switch Chapter 2 HABP Configuration
2-2
Operation Command Description
Configure the
interval to send
HABP request
packets.
habp timer interval
Optional
The default interval for an HABP
server to send HABP request
packets is 20 seconds.
2.3 HABP Client Configuration
HABP clients reside on switches attached to HABP servers. After you enable HABP for
a switch, the switch operates as an HABP client by default. So you only need to enable
HABP on a switch to make it an HABP client.
Table 2-2
Configure an HABP client
Operation Command Description
Enter system view system-view —
Enable HABP
habp enable
Optional
HABP is enabled by default. And a switch
operates as an HABP client after you
enable HABP for it.
2.4 Displaying HABP
After performing the above configuration, you can display and verify your HABP-related
configuration by execute the display command in any view.
Table 2-3
Display HABP
Operation Command Description
Display HABP configuration and
status
display habp
Display the MAC address table
maintained by HABP
display habp table
Display statistics on HABP packets
display habp traffic
These commands
can be executed in
any view.