H3C Technologies H3C S3100 Series Switches - Manual (Page 413)

Operation Manual – Mirroring
H3C S3100-52P Ethernet Switch Chapter 1 Mirroring Configuration
1-4
packets sent by the port; both means to mirror the packets received and sent by
the port.
z
The destination port is determined.
z
The mirroring group number is determined.
II. Configuring port mirroring in Ethernet port view
Table 1-2
Configure port mirroring in Ethernet port view (1)
Operation Command Description
Enter system view
system-view
—
Create a port mirroring
group
mirroring-group group-id
local
Required
Enter Ethernet port
view of the determined
destination port
interface interface-type
interface-number
—
Define the current port
as the destination port
monitor-port
Required
LACP and TCP must be
disabled on the destination
port.
Exit current view
quit
—
Enter Ethernet port
view of the determined
source port
interface interface-type
interface-number
—
Define the current port
as the source port and
specify the direction of
the packets to be
mirrored
mirroring-port
{ inbound |
outbound
| both }
Required
Display the mirroring
parameter settings
display mirroring-group
{ all | local }
Optional
This command can be
executed in any view.
Note:
If you specify the destination port and source port in Ethernet port view without creating
a port mirroring group, mirroring group 1 will be created automatically.