H3C Technologies H3C S3100 Series Switches - Manual (Page 183)

Operation Manual – MSTP
H3C S3100-52P Ethernet Switch
Chapter 1 MSTP Configuration
1-8
Operation Description Related section
Configure the MSTP
operation mode
Optional
Section 1.2.6
“Configuring the MSTP
Operation Mode”
Configure the maximum
hops of MST region
Optional
Section 1.2.7
“Configuring the
Maximum Hops of MST
Region”
Configure the network
diameter of the switched
network Optional
The default value is
recommended.
Section 1.2.8
“Configuring the Network
Diameter of the Switched
Network”
Configure the MSTP
time-related parameters
Optional
The default values are
recommended. Section 1.2.9
“Configuring the MSTP
Time-related Parameters”
Configure the timeout
time factor
Optional
Section 1.2.10
“Configuring the Timeout
Time Factor”
Configure the maximum
transmitting speed on the
current port Optional
The default value is
recommended.
Section 1.2.11
“Configuring the
Maximum Transmitting
Speed on the Current
Port”
Configure the current port
as an edge port
Optional
Section 1.2.12
“Configuring the Current
Port as an Edge Port”
Specify whether the link
connected to a port is a
point-to-point link
Optional
Section 1.2.13
“Specifying Whether the
Link Connected to a Port
Is Point-to-point Link”
Note:
In a network containing switches with both GVRP and MSTP enabled, GVRP packets
are forwarded along the CIST. If you want to advertise packets of a specific VLAN
through GVRP, be sure to map the VLAN to the CIST when configuring the MSTP
VLAN mapping table (the CIST of a network is spanning tree instance 0).
1.2.1 Configuration Prerequisites
The role (root, branch, or leaf) of each switch in each spanning tree instance is
determined.