H3C Technologies H3C S3100 Series Switches - Manual (Page 581)

Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
Chapter 1 BootROM and Host Software
Loading
1-9
At the prompt "Enter your choice(0-9):" in the Boot Menu, press <6> or , and
then press to enter the BootROM update menu shown below:
Bootrom update menu:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
Step 4: Enter 1 to in the above menu to download the BootROM software using TFTP.
Then set the following TFTP-related parameters as required:
Load File name :S3100-52P.btm
Switch IP address :1.1.1.2
Server IP address :1.1.1.1
Step 5: Press . The system displays the following information:
Are you sure to update your bootrom?Yes or No(Y/N)
Step 6: Enter Y to start file downloading or N to return to the Bootrom update menu. If
you enter Y, the system begins to download and update the BootROM software. Upon
completion, the system displays the following information:
Loading........................................done
Bootrom updating..........done!
III. Loading host software
Follow these steps to load the host software.
Step 1: Select <1> in Boot Menu and press . The system displays the following
information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
Step 2: Enter 1 in the above menu to download the host software using TFTP.
The subsequent steps are the same as those for loading the BootROM program,
except that the system gives the prompt for host software loading instead of BootROM
loading.